Perle Systems P840 User Manual download pdf (Page 38)

Event Logs

* Running in System Load mode

Generated when entering System Load Mode in preparation for a download of code to be burned into flash.

* SECURITY ALERT: SNMP community <X> has write access enabled to “ALL” hosts

The SNMP community displayed has had write access enabled to all hosts on the network; anyone may access any

host to make changes.

* Service added to firewall

The IP address of the Service added to the table of services available through the firewall.

* Service removed from firewall

The IP address of the Service removed from the table of services available through the firewall.

* Telnet server removed from firewall

The IP address of the Telnet server removed from the table of services available through the firewall.

* Telnet server added to firewall

The IP address of the Telnet server added to the table of services available through the firewall.

* TFTP: Abort. ACK retry exceeded

Aborted a TFTP session because the bridge/router did not receive a new data packet within the TFTP “T1”

times “N2” interval.

* TFTP: Abort. ACK timeout

Aborted a TFTP session because the bridge/router did not receive an ACK for the last data packet it sent

within the TFTP “T1” times “N2” interval.

* TFTP: Abort. Error (#) received

Aborted a TFTP session because of the reception of a TFTP error message from the connected device. The

errors are: 0 - not defined, 1 - file not found, 2 - access violation, 3 - disk full or allocation exceeded, 4 -

illegal TFTP operation, 5 - unknown transfer ID, 6 - file already exists, 7 - no such user.

* Unable to allocate memory for DHCP server save

Generated when the memory on this device has become too fragmented to find a contiguous block of memory large

enough for the DHCP server tables. Reset the device to defragment memory.

* Unable to bind UDP Boot P client port

Generated as a result of an internal device error. Try resetting the device. If this is unsuccessful, contact a

service representative.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 57 58

No comments

Perle Systems P840 User Manual Page 38