Perle Systems P840 User Manual download pdf (Page 29)

Event Logs

Alarm logs:

* Bad internal block checksum detected

Generated when power up diagnostics finds a fault in the internal block of the EEPROM.

* Closing remote site X (call limit)

Generated when the specified number of calls has been exceeded.

* Closing remote site X (callback failure)

Generated when the remote site interpreted the call sequence as a callback. However, a callback was not

completed in the expected time frame.

* Closing remote site X (force disconnect)

Generated when the connection to a remote site is being closed due to a force disconnect.

* Closing remote site X (inactivity)

Generated when the connection to a remote site is being closed due to an inactivity timeout.

* Closing remote site X (IP triggered RIP)

Generated when the connection to a remote site is being closed due to failure of IP triggered RIP.

* Closing remote site X (last session)

Generated due to the termination of the last session.

* Closing remote site X (link disabled)

Generated due to the link being disabled by the operator.

* Closing remote site X (no NCPs open)

Generated when no Network Control Protocols operating.

* Closing remote site X (nonexistant)

Generated when remote site being deleted by the operator.

* Closing remote site X (not enabled)

Generated when remote site autocall being disabled by the operator.

* Closing remote site X (resumption failure)

Generated due to failure to resume a suspended connection.

* Closing remote site X (scheduled down)

Generated due to time-of-day schedule deactivation of the connection.

* Closing remote site X (suspension timeout)

Generated due to reaching maximum time that the connection may be suspended.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 57 58

No comments

Perle Systems P840 User Manual Page 29