Perle Systems 5500208-41 User Manual download pdf (Page 39)

IOLAN DS1/TS2 CLI Reference Guide, Version 4.1 39

Line Commands Chapter 4

This chapter defines all the CLI commands associated with configuring the IOLAN’s line parameters.

1-Port vs. 2-Port Line Commands

If you are using a DS1 IOLAN, the admin user does not have the option of using the number or all

(*) options in the line commands, as there is only one line. In an TS2 IOLAN, the admin user must

specify

. (current line), <number> (line number), or * (sets value for all lines) when configuring

lines.

Line Commands

Set Line

Description Configures line parameters.

User Level Admin

Syntax

set line .|<number>|* [data-bits 5|6|7|8] [break on|off]

[break-delay <0-65535>] [break-length <0-65535>]

[connection-method dial-in|dial-out|dial-in-out|direct-connect]

[idle-timer <0-4294967>] [line-name <name>]

[modem-name <config_modem>] [pages 1|2|3|4|5|6|7]

[parity none|even|odd|mark|space] [phone-number <phone_number>]

[rev-sess-security on|off] [send-name on|off] [session-strings

|delay <0-65535> |initiate <text> |terminate <text>] [sess-timer

<0-4294967>]

[stop-bits 1|2|1.5] [termtype wyse60|vt100|ansi|dumb|tvi925|

Admin

set line ... flowin on|off] [flowout on|off] [hotkey-prefix

<00-7f>] [data-logging on|off]

[initiate-connection any-char|specific-char <hex_value>]

[initial cli|menu] [keepalive on|off] [lock on|off]

[mode enabled|disabled][motd on|off] [reset on|off]

[dial-timeout <number>] [dial-retries <number>]

[single-character on|off] [user <name>] [nouser]

[internet-address <IPv4_address>] [user <config_user>]

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 92 93

No comments

Perle Systems 5500208-41 User Manual Page 39