Perle Systems 5500208-41 User Manual download pdf (Page 82)

Set IOChannel

82 IOLAN DS1/TS2 CLI Reference Guide, Version 4.1

type

Specify the type of digital output:

z Sink—Specifies that the channel will be grounded when active.

z Source—Specifies that the channel will provide voltage when active.

z Sink and Source—Specifies that channel will be grounded when it is inactive and

will provide voltage when it is active.

The default is

Sink.

active-signal-width

How long the channel output will be active during the pulse mode. Valid values are

1-9999 x 100 ms. The default is 100 ms.

inactive-signal-width

How long the channel output will remain inactive during pulse mode. Valid values are

1-9999 x 100 ms. The default is 100 ms.

failsafe-action

When there has been no I/O activity within the specified time (set in the Global

Settings) and the

Failsafe Timer is triggered, you can set the Failsafe Action to:

z None—The state of the Digital/Relay output remains the same, no change.

z Activate Output—Activates the output.

z Deactivate Output—Deactivates the output.

output

Specify how the channel Digital output will be handled:

z Manual—You must manually activate and deactivate the output.

z Pulse—When the output is activated, this configuration will cause the output to

pulse (go active and inactive) at a configured rate.

z Inactive-to-Active Delay—The channel output will remain inactive for the

specified time interval after it is manually started.

z Active-to-Inactive Delay—The channel output will go inactive after the specified

time interval after it is manually started.

The default is

Manual.

pulse

When the Output is Pulse, you can have it pulse in a Continuous manner or specify a

pulse Count (each count consists of an active/inactive sequence). The default is

Continuous.

active-to-inactive-delay

When the I/O is commanded to an inactive state, this is the length of the delay before

the command is executed. Valid values are 1-9999 x 100 ms. The default is 100 ms.

inactive-to-active-delay

When the I/O is commanded to an active state, this is the length of the delay before the

command is executed. Valid values are 1-9999 x 100 ms. The default is 100 ms.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 92 93

Comments to this Manuals

No comments

Perle Systems 5500208-41 User Manual Page 82

Comments to this Manuals

Related products and manuals for Networking Perle Systems 5500208-41