Perle Systems 5500208-41 User Manual Page 46
- Page / 93
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Line Commands
46 IOLAN DS1/TS2 CLI Reference Guide, Version 4.1
<host_port>
The port number the target host is listening on for incoming connections.
direct
Direct connections bypass the IOLAN, enabling the user to log straight into a specific
host. A direct connection is recommended where a user logging in to the IOLAN is not
required. It is also recommended where multiple sessions are not a requirement. The
message
Press return to continue is displayed on the users screen. The user
must press a key to display the host login prompt. The message is redisplayed on
logout.
silent
Silent connections are the same as direct connections, except they are permanently
established. The host login prompt is displayed on the screen. Logging out redisplays
this prompt. Silent connections, unlike direct connections, however, make permanent
use of pseudo tty resources and therefore consume host resources even when not in use.
raw
Creates a connection where no authentication takes place and data is passed unchanged.
telnet
Sets the line for a telnet connection.
reverse
Enables a TCP/IP host to establish a login connection on an external machine attached
to a port. For example, to access machines like protocol converters, statistical
multiplexors, or machines like routers, firewalls, servers, etc.
dslogin
The default connection. The IOLAN displays a login on that line. For example,
DSLogin is used when a System Administrator configures the IOLAN or users starts a
session(s) from the IOLAN to hosts.
udp
Sets the line to listen for and/or send UDP data.
vmodem
The IOLAN port behaves as if it were a modem to the attached device.
client-tunnel
Sets the line for a client tunnel connection.
server-tunnel
Sets the line for a server tunnel connection.
modbus-master
Sets the line to act as a Modbus master.
custom-app
Sets the line to use the custom application created with the SDK.
trueport
Sets the line to communicate with the TruePort utility. You must install the TruePort
utility on the host machine.
- DS1/TS2 1
- Command Line Interface 1
- Reference Guide 1
- Table of Contents 3
- About This Book 11
- Intended Audience 11
- Contacting Technical Support 12
- Repair Procedure 13
- Feedback on this Manual 13
- Introduction Chapter 1 15
- Command Shortcuts 16
- Command Options 16
- Server Commands Chapter 2 17
- Set Service 19
- Hardware Commands 20
- Modbus Commands 21
- TruePort Baud Commands 22
- IPv6 Commands 23
- Add Custom-IPv6 24
- Set Custom-IPv6 24
- Delete Custom-IPv6 25
- User Commands Chapter 3 27
- Set Termtype 28
- Set User 29
- Set User Session 29
- Show Line Users 30
- Syslog Console 30
- Show Sessions 30
- Show Termtype 30
- Configuring Users 32
- Show Default User 37
- Show User 37
- Line Commands Chapter 4 39
- Set Line Interface 44
- Set Line Service 45
- Line Commands 46
- Set Modem 47
- Line Service Commands 48
- Set Telnet-Client 49
- Set Vmodem 51
- Set Vmodem-Phone 52
- Set Modbus-Slave Line 53
- Set Modbus-Master Line 53
- Set Multihost Line 54
- Set Line Initiate-Connection 54
- Modem Commands 56
- Packet Forwarding Commands 57
- Transmit Timer 58
- Show Packet-Forwarding Line 59
- Network Commands Chapter 5 61
- Delete Community 62
- Delete Trap 62
- Set SNMP 62
- Show SNMP 62
- TFTP Commands 63
- Hosts Commands 63
- Gateway Commands 64
- Set Gateway 65
- Show Gateways 65
- Logging Commands 66
- Time Commands Chapter 6 67
- Show Date 68
- Show Time 68
- Administration 69
- Commands Chapter 7 69
- Set Bootup 70
- Show ARP 70
- Show Bootup 70
- TFTP File Transfer Commands 71
- Custom Factory Default 72
- MOTD Commands 73
- Statistic Commands Chapter 8 75
- Run-Time Statistics 76
- I/O Commands Chapter 9 77
- Set Line 78
- Set IOChannel 79
- Set IOChannel Digital Output 81
- Set IOChannel Relay 83
- Set IOChannel IOExtension 88
- Set IOChannel Multihost 90
- Show IOChannel Status 90
- Kill IOChannel 90
- Show IOChannel 91
- I/O Channel Control Commands 92
- Glossary 93
Related products and manuals for Networking Perle Systems 5500208-41
Networking Perle Systems RPS1630 User Manual
(72 pages)
(72 pages)
Networking Perle Systems 1700 User Manual
(100 pages)
(100 pages)
Networking Perle Systems Switch DS1 User Manual
(246 pages)
(246 pages)
Networking Perle Systems IOLAN SCS User Manual
(408 pages)
(408 pages)
© 2020, manymanuals.com. All rights reserved. | 0.231 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals