Perle Systems 5500208-41 User Manual download pdf (Page 40)

Line Commands

40 IOLAN DS1/TS2 CLI Reference Guide, Version 4.1

Options break

Specifies how a break is interpreted:

z off—The IOLAN ignores the break key completely and it is not passed through to

the host. This is the default setting.

z local—The IOLAN deals with the break locally. If the user is in a session, the

break key has the same effect as a hot key.

z remote—When the break key is pressed, the IOLAN translates this into a telnet

break signal which it sends to the host machine.

z break-interrupt—On some systems such as SunOS, XENIX, and AIX, a break

received from the peripheral is not passed to the client properly. If the client wishes

to make the break act like an interrupt key (for example, when the stty options

-ignbrk and brkintr are set).

break-length

The length of time (in milliseconds) for which the break signal will be asserted on the se-

rial port. Valid values are 0-65535.

Default is 1000 ms

A value of 0 will cause the "request to send a break signal" to be ignored.

break-delay

The length of time (in milliseconds) to delay after a break signal is sent before the IOLAN

sends data. Valid values are 0-65535.

Default: 0 ms ( no delay )

connection-method

Determines how a modem will work on the line. Select from the following options:

z Direct Connect—Indicates that there is not a modem on the line. This is the

default.

z Dial In—Specify this option when a user is remote and will be dialing in via

modem or ISDN TA.

z Dial Out—Specify this option when a modem is attached to the serial port and is

being used to dial out.

z Dial In/Out—Specify this option when the IOLAN is being used as a router

(depending on which end of the link your IOLAN is situated and how you want to

initiate the communication).

data-bits

Specifies the number of bits in a byte. The default is 8.

dial-timeout

The number of seconds the IOLAN will wait to establish a connection to a remote

modem. The default value is 45 seconds.

dial-retries

The number of times the IOLAN will attempt to establish a connection with a remote

modem. The default value is

flowin

Determines if input flow control is to be used. Default is On. This is active only when

Line Flow Control is set to Soft, Hard, or Both.

flowout

Determines if output flow control is to be used. Default is On. This is active only when

Line Flow Control is set to Soft, Hard, or Both.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 92 93

Comments to this Manuals

No comments

Perle Systems 5500208-41 User Manual Page 40

Comments to this Manuals

Related products and manuals for Networking Perle Systems 5500208-41