Perle Systems 5500208-41 User Manual download pdf (Page 53)

Line Service Commands

Set Modbus-Slave Line

Description Sets the Modbus slave parameters for the line.

User Level Admin

Syntax

Options crlf

protocol

uid-range

Set Modbus-Master Line

<IP_address>

Specify the IP address of the remote host that is receiving the vmodem connection.

<TCP_port>

Specify the TCP port that the remote host is lisening on for the vmodem connection.

delete

Deletes the specified entry from the phone number table.

set modbus-slave line .|<number>|* [crlf on|off]

[protocol rtu|ascii] [uid-range <uid_range>]

When Modbus/ASCII is selected, adds a CR/LF to the end of the transmission; most

Modbus devices require this option. The default is

On.

Specify the protocol that is used between the Modbus Master(s) and Modbus Slave(s),

either RTU or ASCII.

You can specify a range of UIDs (1-247), in addition to individual UIDs. The format is

comma delimited; for example, 2-35, 50, 100-103.

Description Sets the Modbus master parameters for the line.

User Level Admin

Syntax

set modbus-master line .|<number>|* [crlf on|off]

[protocol rtu|ascii]

[[entry <number> [port <port>] [protocol udp|tcp]

[range-mode gateway|host] [slave-ip <IP_address>]

[uid-range <start_uid> <end_uid>]]

Options crlf

When Modbus/ASCII is selected, adds a CR/LF to the end of the transmission; most

Modbus devices require this option. The default is

On.

protocol

Specify the protocol that is used between the Modbus Master(s) and Modbus Slave(s),

either RTU or ASCII.

entry

You can specify up to 16 Modbus Slave Remote IP Mapping entries (the UIDs must not

overlap).

port

The destination port of the remote Modbus TCP Slave that the IOLAN will connect to.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 92 93

Comments to this Manuals

No comments

Perle Systems 5500208-41 User Manual Page 53

Comments to this Manuals

Related products and manuals for Networking Perle Systems 5500208-41