Perle Systems 5500208-41 User Manual download pdf (Page 77)

IOLAN DS1/TS2 CLI Reference Guide, Version 4.1 77

I/O Commands Chapter 9

This chapter defines all the CLI commands associated with configuring the IOLAN’s I/O parameters.

Global I/O Commands

Set IO UDP

Description Sets the UDP settings for I/O unicast messages.

User Level Admin

Syntax

Options mode

broadcast-interval

entry

You can specify up to four sets of UDP IP address that will receive the I/O unicast.

udp_port

start_ip

end_ip

set io udp [mode on|off]

[broadcast-interval <broadcast_interval>]

set io udp entry 1|2|3|4 disabled

set io udp entry 1|2|3|4 <udp_port> <start_ip> [<end_ip>]

Enables/disables UDP broadcast of I/O channel status (data).

Enter the interval, in seconds, for UDP broadcasts of I/O channel status (data). Valid

values are 1-9999. Default value is 30 seconds.

The UDP port that the IOLAN will use to relay messages to servers/hosts.

The first host IP address in the range of IP addresses (for IPV4 or IPV6) that the

IOLAN will listen for messages from and/or send messages to.

The last host IP address in the range of IP addresses (for IPV4, not required for IPV6)

that the IOLAN will listen for messages from and/or send messages to.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 92 93

No comments

Perle Systems 5500208-41 User Manual Page 77