Perle Systems 5500208-41 User Manual download pdf (Page 59)

Packet Forwarding Commands

Show Packet-Forwarding Line

Description Shows the packet-forwarding settings for the line.

User Level Admin

Syntax

force-transmit-timer

When the specified amount of time, in milliseconds, elapses after the first character is

received from the serial port, the packet is transmitted. After a packet is transmitted, the

next character received starts the timer again. A value of zero (0) ignores this

parameter. Valid values are 0-65535 ms. The default is 0.

forwarding-rule

Determines what is included in the Frame (based on the EOF1 or EOF1/EOF2) or

Packet (based on Trigger1 or Trigger1/Trigger2). Choose one of the following options:

z Strip-Trigger—Strips out the EOF1, EOF1/EOF2, Trigger1, or Trigger1/Trigger2,

depending on your settings.

z Trigger—Includes the EOF1, EOF1/EOF2, Trigger1, or Trigger1/Trigger2,

depending on your settings.

z Trigger+1—Includes the EOF1, EOF1/EOF2, Trigger1, or Trigger1/Trigger2,

depending on your settings, plus the first byte that follows the trigger.

z Trigger+2—Includes the EOF1, EOF1/EOF2, Trigger1, or Trigger1/Trigger2,

depending on your settings, plus the next two bytes received after the trigger.

idle-timer

The amount of time, in milliseconds, that must elapse between characters before the

packet is transmitted to the network. A value of zero (0) ignores this parameter. Valid

values are 0-65535 ms. The default is 0.

packet-size

The number of byte that must be received from the serial port before the packet is

transmitted to the network. A value of zero (0) ignores this parameter. Valid values are

0-1024 bytes. The default is 0.

sof1

When enabled, the Start of Frame character defines the first character of the frame, any

character(s) received before the Start of Frame character is ignored. Valid values are in

hex 0-FF. The default is 0.

sof2

When enabled, creates a sequence of characters that must be received to create the start

of the frame (if the SOF1 character is not immediately followed by the SOF2 character,

the IOLAN waits for another SOF1 character to start the SOF1/SOF2 character

sequence). Valid values are in hex 0-FF. The default is 0.

start-frame-transmit

When enabled, the SOF1 or SOF1/SOF2 characters will be transmitted with the frame.

If not enabled, the SOF1 or SOF1/SOF2 characters will be stripped from the

transmission.

show packet-forwarding line [<number>]

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 92 93

Comments to this Manuals

No comments

Perle Systems 5500208-41 User Manual Page 59

Comments to this Manuals

Related products and manuals for Networking Perle Systems 5500208-41