Perle Systems 5500208-41 User Manual download pdf (Page 85)

Set IOChannel

alarm

Configures alarm settings when the Analog input trigger is activated.

level

You can specify up to five alarm trigger/clear severity levels. If the Trigger Type is

Low, an alarm is triggered when the input drops below the specified Trigger value;

other severity level trigger values must decrease in value with each subsequent level. If

the

Trigger Type is High, an alarm is triggered when the input is higher than the

specified Trigger value; other severity level trigger values must increase in value with

each subsequent level. To clear an alarm, the input must drop below the specified value

when

Trigger Type is High or go above the specified value when Trigger Type is Low.

mode

Enables/disables an alarm level. The default is off.

trigger-type

If the Trigger Type is Low, an alarm is triggered when the input drops below the

specified

Trigger value; other severity level trigger values must decrease in value with

each subsequent level. If the

Trigger Type is High, an alarm is triggered when the input

is higher than the specified

Trigger value; other severity level trigger values must

increase in value with each subsequent level.

trigger-level

Specify the value that will trigger an alarm, the measurement is based on the Type and

Range that you specify. This value must not fall within the scope of the value used to

clear an alarm.

clear-mode

Specifies whether an activated alarm must be Manually cleared, or can be cleared when

the input drops below the specified value (when

Trigger Type is High) or goes above

the specified value (when

Trigger Type is Low).

clear-level

Specify that value that will clear an alarm, the measurement is based on the Type and

Range that you specify. This value must not fall within the scope of the value used to

trigger an alarm.

snmp

Sends an SNMP trap when an alarm is triggered or cleared. The trap consists of the

severity level and whether the alarm was triggered or cleared.

syslog

Sends a message to syslog when an alarm is triggered or cleared. The syslog entry

includes the severity level and the value that caused the alarm to trigger or clear. The

syslog message is associated with

Level Critical.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 91 92 93

Comments to this Manuals

No comments

Perle Systems 5500208-41 User Manual Page 85

Comments to this Manuals

Related products and manuals for Networking Perle Systems 5500208-41